108
Chapter 7 - Troubleshooting Procedures
3
Place your local MultiMux in normal operating mode by shutting
power off and turning it back on. Make sure your 8-position DIP
switch SW1 is in the off (closed) position.
4
With the two MultiMuxes in your network set properly, you can now
enter data on the keyboard of each channel device and, if the
network is operating correctly, the data will be correctly displayed on
the channel device monitor. If the channel device is equipped with an
active local echo feature, double characters will be displayed.
5
When you have verified that the communications line and modems
are working correctly, have the operator at the other end of your
network place the MultiMux in normal operating mode by reversing
step 1 (if necessary) and shutting power off then on to the unit.
Summary of Contents for MMH900
