47
Chapter 4 - Installation
External modem with V.35 interface is being connected: Remove
the top cover and move the V.24/V.35 shunt from the V.24 position to
the V.35 position. Replace the top cover.
1 2 3 4 5 6 7 8
1 2 3 4
V.35 V.24
OTHER RKWL14.4
V29/V33
2834
Systems
MultiTech
MMH956
V.35 Shunt
V.24 Shunt
V.29/V.33
Shunt
2834 Shunt
Figure 4-2. Shunts
2
Connect the AC power cord shipped with your MultiMux to the AC
power connector on the back panel and to the AC outlet.
3
Press the power ON/OFF switch on the back panel of the MultiMux
to apply power.
4
If the internal composite link modem is V.34/28800 bps, verify that
the INTERNAL LINK DEVICE Modem MMH2834 LED on the front
panel is ON.
If your MultiMux is configured for an external composite link sync
modem, verify that the External Composite Link XMT and CTS LEDs
are ON. If the external composite link modem has a V.35 interface,
verify that the V.35 LED is also ON.
If a DSU is installed in your MultiMux, verify that the 56K DSU LED
is ON.
Summary of Contents for MMH900
