59
Chapter 5 - Commands
The H1 Menu is as follows:
CHANNEL PARAMETER COMMANDS
B
BAUD RATE SELECTION
P
PARITY SELECTION
C
CHANNEL SELECTION
R
RESPONSE TIME PRIORITY
DC
DEST. CHANNEL SELECTION
SB
STOP BIT SELECTION
DN
DEST. NODE SELECTION
SN
LOCAL SOURCE NODE NUMBER
E
LOCAL ECHO
#S
CHANNEL STATISTICS
F
FLOW CONTROL
&SL
SELECT LOCAL PARAMETERS
&F
READ IN FACTORY DEFAULTS
&SR
SELECT DOWNLINE LOAD PARAMETERS
L
LIST PARAMETERS
WL
WORD LENGTH SELECTION
The following example will select CHANNEL 1 and set its baud rate to
2400 and the WORD LENGTH to 8 bits:
ATC1B2400WL8 <ENTER>
For HELP on a specific command, enter “ATH” followed by a command
letter.
Summary of Contents for MMH900
