73
Chapter 5 - Commands
5.2.3
Composite Link Commands
The Composite Link commands perform the function of a system
monitor. In addition to displaying the information available on the
MultiMux’s LED display, they also provide additional network statistical
information. The purpose of the commands are to allow network
monitoring via the supervisory port as an alternative to viewing the LED
indicators. The various status commands and their functions are detailed
below:
Command
Description
#C
Clear Composite Statistics
The Clear Composite Statistics command clears the
composite statistics record without resetting the
entire MultiMux unit.
$F
Load Modem Default
The Load Modem Default command returns the
status of the internal composite link modem or
DSU to its original status as shipped from the
factory. The default conditions for a 9600 bps
modem are as follows:
Speed:
9600
RCV Level:
-43 dbm
TX Level:
0 dbm
Cable Equalization:
0.0km
Link Amp:
off
Link Delay:
off
T/2 Equalization:
T2
Echo Protect:
off
Test Mode:
off
#FT
Flush Timer Value
This command is necessary when the mux is used
with Alpha-Microcomputer and Wyse Terminals. The
command allows for the proper use of the function
keys as indicated on the keys. The #FT0 command
clears the function and sets the flush time value to
Summary of Contents for MMH900
