85
Chapter 5 - Commands
5.2.7
Internal Composite Link DSU
Commands
Command
Description
$DSUCL
DSU Clock
The DSU Clock command allows the internal DSU
to accept timing from it's internal timing oscillator
($DSUCLI) or from the DDS Network's Receive
Bipolar Signal. DDS Clocking command
($DSUCLD) is used whenever the internal DSU is
connected to DDS network line. The $DSUCLD
command is the factory default and automatically
configures the MultiMux clocking.
$DSUSP
DSU Speed
The DSU Speed command sets the speed of the
internal DSU. The default DSU speed is 56000 bps.
The DSU speed commands are as follows:
$DSUSP2400
$DSUSP4800
$DSUSP9600
$DSUSP19200
$DSUSP56000
Summary of Contents for MMH900
