88
Chapter 5 - Commands
5.2.9
Command Modem commands
The command modem select and remote access commands are
described in this section. Additional command modem AT commands
are provided in Appendix D.
Command
Description
#MA
Command Modem Select
The Command Modem Select command (#MA1)
sends all subsequent commands generated on your
supervisory console to the command modem. The
various commands for the command modem are AT
command set compatible with those described in
Appendix D. The #MA1 command enables the
command modem.The #MA0 command disables the
command modem input and hangs up the phone
line.
#RA
Remote Command Modem Access
The Remote Command Modem Access (#RA1)
command allows commands to be received by a
MultiMux through it command modem (allows the
command modem to answer an incoming call). This
permits updating of the mux remotely through the
command modem. All commands received on the
command modem after calling in will be accepted by
the mux as if they were generated by a supervisory
console. This condition will exist as long as there is
a carrier established. The #RA0 command disabled
remote input through the command modem access
(disables Atuo Answering).
Summary of Contents for MMH900
