Chapter 3 – Using the Web Management Software
30
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Caller Acknowledgement Configuration
Acknowledgement String to Caller:
The configured string of (0 to 40 characters) will be sent to the integrated cellular
modem upon receiving a valid caller ID from the WAN. The default is NULL string.
Note:
If the string is not configured, acknowledgement to the caller will not be sent upon successful
caller ID reception.
Submit
Click the
SUBMIT
button to save these settings.
Note:
You must click
Save and Restart
once you have completed and submitted all the screens on which you have made
changes.
PPP > Wakeup-On-Call Examples
Example 1 – Determine if the router Is Supporting Incoming Calls and Caller ID
1.
On the
PPP > PPP Configuration
screen, make sure that
PPP
is
Disabled
.
2.
On the
PPP > Wakeup-on-Call
screen, make sure that
Wakeup-on-Call
is
Disabled
.
3.
Open a command prompt by clicking the
Start
button and selecting
Run
.
4.
Type
CMD
to open the command window. Click
OK
.
5.
When the command window opens,
telnet
to the router
.
Note:
5000 is the router port number.
5.1.
Enter your username and password to login.
5.2.
Enter an AT command to make sure you receive a response; i.e.,
OK
.
5.3.
On HSPA modlels, enter the Command
AT+CNUM
to determine the dial number of your router.
6.
From another phone, call your router using the number identified in Step 5.3. This will let you know if the RING
message shows.
7.
To enable Caller ID, enter the
AT+CLIP=1
command on the command screen and make the call again to see if it
shows Caller ID information.
Notes:
●
Step 5.3 must show the RING or CALLER ID information in order for the Wakeup-on-Call function to work.
●
Some wireless providers might not provide caller ID information if you have only a data plan.
Example 2 – Set Up the Ethernet Router to Activate on ALL Incoming Calls
1.
On the
PPP >PPP Configuration
screen, set up the following parameters:
PPP General
●
Make sure that
PPP
is
Enabled
.
●
Make sure
Dial-on-Demand
is
Enabled
.
●
Set the
Idle Time Out
to the number of seconds you desire.
Authentication
●
Your wireless service provider may require you to have a separate PPP
Use name
and
Password
. If so,
enter them here.
Note:
If a username and password are required, your wireless provider would have given them to you when
you activated your account.
Modem Configuration
●
Make sure your
Dial Number
is entered correctly:
For HSPA models, the Dial Number is
*99***1#
For EV-DO models, the Dial Number is
#777
Submit
●
Click the
Submit
button to save the changes made on this screen.
2.
On the
PPP > Wakeup-on-Call
screen, set up the following parameters:
Wakeup-on-Call Configuration
●
Select
Enable
for
Wakeup-on-Call
.
●
Set the
Time Delay
to
3
seconds. You can use the 10 second default.
●
All
Init Strings
should be empty.
●
Submit
Button
Click
the
Submit
button to save these settings.
Caller ID Configuration
●
Enter the string
RING
to the Caller ID list.
●
Click the
Add
Button to save the string to the Caller ID list.
3.
Save and Restart
Summary of Contents for MTCBA-EV1-EN3-N3
Page 1: ...MultiModem rCell Intelligent Wireless Router User Guide ...
Page 18: ......
