Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem rCell User Guide
31
Click
Save and Restart
once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.
Example 3 – Set Up the Ethernet Router to Activate on Matching Caller IDs Only:
1.
On the
PPP > PPP Configuration
screen, set up the following parameters:
PPP General
●
Make sure that
PPP
is
Enabled
.
●
Make sure
Dial-on-Demand
is
Enabled
.
●
Set the
Idle Time Out
to the number of seconds you desire.
Authentication
●
Your wireless service provider may require you to have a separate PPP
username
and
password
. If so,
enter them here.
Note:
If a username and password are required, your wireless provider would have given them to you
when you activated your account.
Modem Configuration
●
Make sure your
Dial Number
is entered correctly:
For HSPA models, the Dial Number is
*99***1#
For EV-DO models, the Dial Number is
#777
Submit
●
Click the
Submit
button to save the changes made on this screen.
2.
On the
PPP > Wakeup-on-Call
screen, set up the following parameters:
Wakeup-on-Call Configuration
●
Select
Enable
for
Wakeup-on-Call
.
●
Set the
Time Delay
. You can use the 10 second default.
●
Enter the
Init Strings:
Set Wakeup
Init String 1
by entering
AT+CLIP=1
for HSPA models only.
●
Submit
Button
Click the
Submit
button to save these settings.
Caller ID Configuration
●
Enter a caller’s ID that you want added to the Caller ID list.
●
Add
Button
Click the
Add
button to save each Caller ID as it is entered to the Caller ID list.
3.
Save and Restart
Click
Save and Restart
once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.
PPP > Power-On Configuration
The Power-On Configuration feature allows you to set an initialization string that will be sent to the router upon boot up.
Power-On Init String Configuration
Power-On Init String:
You can enter a string of 0 to 40 characters that will be sent to the router upon boot up. All
commands will initialize before you proceed with regular PPP related activity.
Note:
When no initialization string is configured, regular functionality of the router is retained.
Submit:
Click the
SUBMIT
button to save this setting.
Note:
You must click
Save and Restart
once you have completed and submitted all the
screens on which you have made changes.
Summary of Contents for MTCBA-EV1-EN3-N3
Page 1: ...MultiModem rCell Intelligent Wireless Router User Guide ...
Page 18: ......
