ANTENNA AND ACTIVATION INFORMATION
Antenna and Activation Information
Antenna
The antenna intended for use with this unit meets the requirements for mobile operating configurations and for
fixed mounted operations, as defined in 2.1091 and 1.1307 of the FCC rules for satisfying RF exposure compliance.
If an alternate antenna is used, consult user documentation for required antenna specifications.
EV-DO and CDMA Antenna Information
EV-DO and CDMA Authorized Antennas
These devices were approved with the following antenna:
Manufacturer:
Exceltek Electronics Ltd.
Manufacturer's Model Number:
C0081-ANG0002
Multi-Tech ordering information:
Model
Quantity
ANQB-1HRA
1
ANQB-10HRA
10
ANQB-50HRA
50
EV-DO and CDMA Antenna Requirements
Category
Description
Frequency Range
824 - 894 MHz / 1850 - 1990 MHz
Impedance
50 Ohms
VSWR
VSWR should not exceed 2.0:1 at any point across the bands of operation
Typical Radiated Gain
2 dBi on azimuth plane
Radiation
Omni-directional
Polarization
Linear vertical
Antenna System Cellular Devices
The cellular/wireless performance depends on the implementation and antenna design. The integration of the
antenna system into the product is a critical part of the design process; therefore, it is essential to consider it early
so the performance is not compromised. If changes are made to the device's certified antenna system, then
recertification will be required by specific network carriers.
Account Activation for Cellular Devices
Some Multi-Tech cellular modems are pre-configured to operate on a specific cellular network. Before you can use
the modem, you must set up a cellular data account with your service provider. Each service provider has its own
MultiConnect
®
Cell 100 Series MTC-EV3 User Guide
13
