MultiVOIP ISDN/BRI Cabling Guide
Multi-Tech Systems, Inc.
3
Introduction
This guide shows you how to make the cable connections to set up your
MultiVOIP
®
ISDN/BRI unit. See the MultiVOIP
User Guide
included on the
MultiVOIP CD for more information. The “Quick Start Instructions” chapter shows
how to get the MultiVOIP ISDN/BRI unit up and running with a basic configuration.
Safety Warnings
Lithium Battery Caution
A lithium battery on the voice/fax channel board provides backup power for the
timekeeping capability. The battery has an estimated life expectancy of ten
years.
When the battery starts to weaken, the date and time may be incorrect. If the
battery fails, the board must be sent back to Multi-Tech Systems for battery
replacement.
Warning:
There is danger of explosion if the battery is incorrectly
replaced.
Ethernet Ports Caution
Caution:
The Ethernet ports and command ports are not designed to
be connected to a Public Telecommunictaion network.
Safety Warnings Telecom
•
Use this product only with UL- and CUL-listed computers (US).
•
Never install phone wiring during a lightning storm.
•
Never install a phone jack in a wet location unless the jack is specifically
designed for wet locations.
•
Never touch uninsulated phone wires or terminals unless the phone line has
been disconnected at the network interface.
•
Use caution when installing or modifying phone lines.
•
Avoid using a phone during an electrical storm; there is a risk of electrical
shock from lightning.
•
Do not use a phone in the vicinity of a gas leak.
•
To reduce the risk of fire, use only 26 AWG or larger telephone line cord.
•
This product must be disconnected from power source and telephone
network interface when servicing.
Safety Recommendations for Rack Instructions
•
Ensure proper installation of the MultiVOIP in a closed or multi-unit
enclosure by following the recommended installation as defined by the
enclosure manufacturer. Do not place the MultiVOIP directly on top of other
equipment or place other equipment directly on top of the MultiVOIP.
•
If installing the MultiVOIP in a closed or multi-unit enclosure, ensure
adequate airflow within the rack so that the maximum recommended
ambient temperature is not exceeded.
