15
Chapter 2 - Installation
Cabling Your ProxyServer
Cabling your ProxyServer involves making the proper Power (PWR), Ethernet (LAN), and WAN
(WAN1, 2, 3) connections. Figure 2-2 shows the back panel connectors and the associated cable
connections. The procedures that follow detail the process of making each connection.
Note: The Command (CMD) port connection is used to connect a PC directly to the ProxyServer for
local configuration and management. The CMD port does not need to be used to set up and
configure the unit.
PC
PHONE
LINE
USB
PWR CMD LAN WAN1 WAN2 WAN3
WAN Connections
Ethernet Connection
Hub
PC Connection
Power
Connection
Figure 2-2. Back Panel Connections
Step
Procedure
1
Verify that the ON/OFF switch, located on the right side panel of the ProxyServer, is set to
the OFF position (toward the front of the unit).
2
Connect the external power supply (included with the ProxyServer) to a live AC outlet and to
the power connector (PWR) on the back panel of the ProxyServer. See Figure 2-2.
3
Make the network connection by connecting an RJ-45 (UTP) cable (you supply) to the LAN
connector on the back of the ProxyServer. Connect the other end of the cable to your LAN.
4
Connect the three short RJ-45 to DB-25 cables (included with the ProxyServer) between the
WAN ports on the ProxyServer and the serial port on the DCE devices (i.e., modem or DSU).
See Figure 2-2.
5
Turn on power to the ProxyServer by placing the ON/OFF switch to the ON position (toward
the back of the unit). Wait for the Boot LED (BT) to go off before proceeding. This may take a
couple of minutes.
At this time your ProxyServer is completely cabled. Proceed to
Chapter 3
to load the ProxyServer
software and run the Wizard Setup.
Summary of Contents for ProxyServer MTPSR3-100
