Chapter 3 – RouteFinder Software Operation
Multi-Tech RouteFinder RF650VPN User Guide
145
The Routing Table menu shows the Kernal IP routing table information in terms of Destination, Gateway,
Genmask, Flags, Metric, Ref(erence), and Use Iface (User Interface).
Destination is the address of the target system.
Gateway is the address of the next-hop router.
Use Iface
(User Interface) indicates the name of the local interface from which the packet is to be
sent.
The interface routes are inserted by the system and cannot be edited.
Further manual entries can be made in the
Network|Routing
menu (described earlier in this
chapter).
The Network connections table shows all the current (Active) network connections to or from your
RouteFinder. Information on the active protocol, receive queue, send queue, local address, foreign
address, and current state is shown for each of the RouteFinder's active Internet connections.
The Network connections table shows you all of the established TCP sessions and all of the TCP and
UDP ports that the RouteFinder is listening to for incoming connections. (Connections through the
RouteFinder are not shown).
