RPR 750IS Series
9261 - 7912 Issue 8
18
When this point has been reached, press the MUTE button
and the minutes will start to flash. Press the OCR button until
the desired minutes are displayed. To complete the set-up,
press the MUTE button and the pager will continue the switch-
on sequence.
To reset the time on a pager which has already been
switched-on, or time incorrectly entered, simply turn the pager
off and on again and follow the set-up sequence.
13. OTHER OPTIONS
Your pager is programmable to offer the following additional
options.
Group Alert
- Your pager may be programmed to operate as
part of a ‘team’. Any group call to your team will activate your
audible alert sequence, even if your pager is in
Mute
mode.
Out of Range
- This option will alert you, if you move outside
of the radio coverage area for your system. The alert is
activated if the pager has not received a valid signal for a pre-
set time, typically 3 minutes, 30 seconds.
Combinations of alert options are available, including visual
only, audible plus visual, or either option plus vibrate. The
audible/visual option enables an
out of range
warning on the
display for 4 seconds, accompanied by a 2 second buzz.
Pagers with the audible warning enabled, will also produce a
buzz when the OCR button is pressed whilst the receiver is
out of range (except in
Mute
mode). For the visual only alert,
just the message is displayed. In all cases when selected, the
vibrate
option will cause several short pulses during the alert
period.
After the 4 second alert period, the pager will either continue
to display the
Out Of Range
message, or if a received
message is being stored, this will be notified until cleared.
