Figure. 6.8.3. - 141. Adjusting the width of the feeder roller
1. Adjust the width of the roller in accordance with the set target rate.
The roller width is set by pressing the number value (2). The roller width is
adjusted within a range of 0-100%. The gure is the relative value of the seeding
rate (50-700 kg) as shown in the table (3). Press SET (1) to accept the value.
Figure. 6.8.3. - 142. Calibration test crank. On the left, a machine without a gearbox and on the right, a
machine equipped with a gearbox.
2. Attach the calibration test crank (1) to the calibration test shaft. Rotate the crank until the
linear actuator has moved to the correct position.
When the linear actuator reaches the correct position, it appears in the SeedPilot
ISOBUS control system push button or on the SeedPilot and SeedPilot ISOBUS
control system controller screen.
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
116 (208)
Summary of Contents for FX300 SeedPilot
