1.How to restore factory settings?
Select “Setting”
→
“Backup&reset”
→
“Factory date
reset”.
2.Why can not power up the PDA?
(1)It needs about 4s to press and hold the power button
to turnon, so please hold the power button until the
screen showing contents.
(2)Please check if the battery are in low power, and
charge the PDA for 30mins, then restart it.
3.When use scanner, there is no data but scan-light
on, Why?
(1) Go to “scanner”app --- setting, and adjust the ‘output
mode’.
(2) Reset the “scanner” app for twice, and switch on
‘Open scan’.
4.The device cannot scan the code.
(1) Check if each scan button can be used normally.
(2) Check if the scan engine supports the bar code.
(3) Check if the scanning lens and bar code is clear and
unobstructed.
(4) Check the scan setting and reset .
Chapter 4 FAQ
30
Summary of Contents for IPDA080
