How To Install
How To Install
7
Getting Started
6
STEP 1: IDENTIFY GATE PLACEMENT
This gate fi ts openings 30" (76.2cm) to 32" (81.3cm).
GATE IS SUITABLE FOR:
TOP OF STAIRS
If installing the gate at the top of stairs, it MUST
be installed on the top landing and only swing away
from the stairway.
BOTTOM OF STAIRS
If installing the gate at the bottom of stairs, we
recommend placing it on the fl oor. If the gate must
be placed on the lowest stair, position it toward the
front of the step.
HALLWAYS AND DOORWAYS
STEP 2: INSTALL LOWER HINGE (WALL BRACKET)
TOOLS NEEDED:
•
Drill
•
Phillips Screwdriver
•
Adhesive Tape
•
Hex Key
•
Pencil
•
Wrench
1.
Cut template along the dotted line to separate template “A” and “B".
2.
Decide which side of your opening will be the hinge side
(i.e. the side that does NOT open). Next, place template
“A” against the wall using tape. The template should be
fl ush to the fl oor/step.
3.
Mark the screw holes in the cut-out piece
with a pencil to create indentation, then
remove the cut-out piece on bottom of
template “A”.
4.
Determine whether there is a stud behind the drywall where you will install the lower
hinge wall bracket. Proceed to either
5a
or
5b
.
PLEASE NOTE:
Leave template “A” in place to help align the upper hinge bracket later.
A
B
Template A
(Hinge side)
Summary of Contents for MKSA0646-REV1
Page 28: ......
