20
1. The inlet and outlet should not be covered so that the outflow air can reach all parts of the room.
2. Install in a location where is permitting easy connection with the outdoor unit.
3. A location from which the condensation water can be drained out conveniently.
4. Avoid a location where there is heat source, high humidity or inflammable gas.
5. Install in a location where is strong enough to withstand the full weight and vibration of the unit.
6. Be sure that the installation conforms to the installation dimension diagram.
7. Be sure to leave enough space to allow access for routine maintenance.
8. Install in a location where is lm or more away from other electric appliances such as television, audio device, etc.
9. Select location where is easy to remove and clean the filter.
10.Be sure that the distance from the location to the ground is more than 2.3m.
Outdoor unit
1. Select location from which noise and outflow air emitted by unit will not inconvenience neighbors.
2. Select location where there should be sufficient ventilation.
3. The inlet and outlet should not be covered.
4. The location should be able to withstand the full weight and vibration of the outdoor unit.
5. There should be no danger of flammable gas or corrosive gas leaks.
6. Be sure that the installation conforms to the installation dimension diagram.
NOTE:
Install in the following place may cause mal - function. If it is unavoidable, contact with service center of
MUNDOCLIMA please.
Place where oil (machine oil ) is used.
The place where a lot of salinities such as coast exists.
Place where a sulfured gas such as the hot spring zones is generated.
Place where high - frequency waves are generated by radio equipment.welders and medical equipment.
Other place with special circumstance.
Indoor unit
H
2
S
Installation location
