- 84 -
Scanning to Local PC
4
Scanning
8
When the balloon message saying that
the installation is complete is displayed
on the task bar, click the balloon to
check the details, and click [Close].
9
Press the <SCAN> key on the operator
panel.
10
Press the to select [Local PC] and
then press
OK
.
11
Check that [Select A Connecting PC]
is selected, and press
OK
.
12
Press the to select [From WSD
Scan], and press
OK
.
13
Check that the computer on which your
machine has been installed is displayed
as the destination PC.
Note
●
If the machine’s IP address is changed after the
installation, uninstall the machine from the computer by
following the same procedure as in
“Step 2 Installing Your
Machine to the Computer” P.83
, and then reinstall it.
For Mac OS X
Overview
Connecting Methods
You can select either of the following connection
methods:
●
Network Connection
●
USB Connection
Product Requirements
Your machine supports Mac OS X 10.6 to 10.7.
Steps to Go
To configure the Scan to Local PC function with
Mac OS X, follow the 3 steps below:
●
“Step 1 Connecting Your Machine and
Computer” P.85
●
“Step 2 Installing a Scanner Driver” P.88
●
“Step 3 Registering Your Computer in Network
Scanner Setup Tool” P.89
Memo
●
For the network connection, you can skip step 1 if the IP
address is already set on your machine.
●
You can skip step 2 if the scanner driver is already
installed on your computer.
●
For the USB connection, skip step 3.
Summary of Contents for MFX-3091
Page 1: ...Quick Start Guide MFX 3091...
Page 119: ......