MGS Installation and Operation Manual
1000-0085 Rev 0
23
IMPORTANT:
Failure to test or calibrate the unit in accordance
with applicable instructions and with industry guidelines may result
in serious injury or death. The manufacturer is not liable for any
loss, injury, or damage arising from improper testing, incorrect
calibration, or inappropriate use of the unit.
IMPORTANT:
Before testing the sensors on-site, the MGS must
have been powered up and allowed to stabilise.
IMPORTANT:
The testing and/or calibration of the unit must be
carried out by a suitably qualified technician, and must be done:
•
in accordance with this manual
•
in compliance with locally applicable guidelines and
regulations.
Suitably qualified operators of the unit should be aware of the
regulations and standards set down by the industry/country for the
testing or calibration of this unit. This manual is only intended as a
guide and, insofar as permitted by law, the manufacturer accepts
no responsibility for the calibration, testing, or operation of this
unit.
The frequency and nature of testing or calibration may be
determined by local regulation or standards.
EN378 and the F-GAS Regulation require an annual check in
accordance with the manufacturer’s recommendation.
NOTE:
For improved accuracy and response, the instrument
should be zeroed and calibrated in the environment in which it is
being installed.
There are two concepts that need to be differentiated:
•
bump test
•
calibration.
