INSTALLATION:
1. Install Chiller and Drinking Fountain Wall
Mounting Frame following the instructions
included with the frame.
4. Install the four threaded studs into the Wall
Mounting Frame.
3. Hang upper trim panel on mounting frame.
Note: The included 1” brackets do not get used
with this installation and the plastic spacers are
typically not required and can be discarded.
2. Verify frame chiller shelf is secure and install the
chiller following the instructions included with
the chiller.
6. Slide fixture over studs and secure with nuts and washers 2 .
5. Remove the drinking fountain bottom access panels 1 . Set the access panels aside in a safe
place where they will not be damaged and place the screws in a secure location where they will not
be lost
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
CONTEMPORARY WATER COOLERS
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
DRINKING FOUNTAINS
A152.8FG
Page 5 of 9
Revised:
07/18/18
7020-006-001
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
16" CENTERLINE
NOTCHES
5
5
8
" FOR 33"
ORIFICE HEIGHT
