48
ENGLISH
8.2.2. Procedure to follow
Step 1 :
The unit stops automatically when the filter is removed.
It is therefore not necessary to switch the power off.
Open the cover. Hold it back so that it does not fall down suddenly.
Step 2 :
Open the insulation foam.
(Take this opportunity to check the inlet grille)
Step 3 :
Use gloves to remove the pollutant-laden filter from its slot.
It is simply held in its notch.
Step 4 :
Place the new filter all the way in its housing. (Arrow pointing
upwards).
Reminder: Use only filters supplied by Murprotec !
(on pain of the guarantee being voided)
Step 5 :
Put back the insulation foam.
8.2. Filter replacement
8.2.1. General
When the filter reaches an operation time, the control module displays “Replace filter.” It is therefore time to carry out
maintenance on your installation.
Each time you remove the filter or after a power failure, the control module will ask whether you have put in a new filter.
If deposits appear, take advantage of this to clean the inside of the cover and the air intake duct: simply unclip the protective
grille.
Tip: Vacuum to remove dirt. Then rub with a damp paper towel to remove the dust. Dry with a dry paper towel.
Do not forget to put the grille back on, as this is useful to prevent elements such as leaves or other objects from prematurely
clogging the filter.
CTA4-Mode-d-emploi(A5)-2021 2/02/21 18:05 Page 50
