ASSEMBLY
8
F–041305C
3. Insert the
right lower handle
into the
mounting channel
(see Figure 3). Make
sure the flat end at the top of the handle
is facing inward.
4. Mount a
spacer
on each
screw
. Push
the
screws
through the
tine shield
, the
lower handle
, and half way through the
engine casing (see Figure 4).
5. Insert the
left lower handle
into the
mounting channel
(see Figure 3). Make
sure the flat end at the top of the handle
is facing inward.
6. Push the
screws
through the engine
casing, the
lower handle
, and the
tine
shield
. Secure with
spacers
and
lock-
nuts
as shown in Figure 4. Do not tight-
en at this time.
7. Remove the fasteners from the
upper
handle
(see Figure 5).
8. Assemble the
upper handle
to the lower
handles with the fasteners removed in
step 7.
9. Tighten the
knobs
.
NOTE: To tighten the knobs, hold the
curved carriage bolt head against the
outside of the lower handle as you
tighten the knobs.
10. Tighten the
locknuts
that hold the ends
of the lower handles (see Figure 4).
Tighten only enough to firmly hold the
handles.
CAUTION: Over tightening the lock-
nuts can change the shape of the han-
dle and damage the engine casing.
11. Mount the
throttle control
on the right
side of the
upper handle
with the
screw
as shown in Figure 5.
12. Attach the throttle control cable to the
lower handle with the
cable fastener
.
Make sure the throttle control cable is
routed to the outside of the handles.
Figure 3
Left Lower
Handle
Right Lower
Handle
Mounting Channel
Screw
Spacer
Spacer
Locknut
Tine Shield
Figure 4
Figure 5
Screw
Throttle Control
Carriage Bolt
Flat
Washer
Curved
Washer
Knob
Upper Handle
Cable Fastener
Summary of Contents for 11052x4NB
Page 66: ...NOTA 66 F 041305C ...
Page 67: ...NOTA 67 F 041305C ...
