13
W-DMX G4 system
<<<<<<
LINK (flashing)
LINK (off)
LINK (off)
<<<<<<<<
LINK (rapid flashing)
<<<<<<<<<<<
DATA (on)
1. Press the function button on the transmitter for 3 seconds, until the LINK LED flashes slowly.
• The LINK LED flashes slowly.
3. Press the function button of the transmitter for 1 second.
• The transmitter scans for all unlinked receivers for a period of about 10 seconds. The LINK LED flash-
es rapidly.
• The signal bars of the receivers fall back to zero.
• All connected receivers are unlinked.
NOTE - To unlink one specific receiver, press and hold the function button on the specific receiver for 3
seconds.
1.7 OPERATION AS A RECEIVER
The unit is in Receive Mode (RX), working as a receiver.
Linking with transmitters
1. Power on the receiver.
2. Ensure that the receiver is not connected to any other transmitter, i.e., the LINK LED on the receiver is
off.
• If the connection is successful, the LINK LED on the receiver goes on. If DMX input is available, the
DATA LED goes on as well.
• If the connection fails, check the position of the receiver, see chapter “Prerequisites for successful
linking”, page 11.
• The signal bar on the receiver indicates the received signal strength.
NOTE - During the link procedure the DMX transmission is interrupted.
Unlinking from transmitters
1. Press the function button on the receiver until the LINK LED goes out.
• The receiver is unlinked.
