SPECIAL FEATURES
SCAN INTRODUCTION
The scan-introduction function allows play
back of just the start of each track on the
disc, for instance to locate a preferred track
by ear.
Press
INTRO on the remote control, and if
the player has stopped, the display will
show :
The first ten seconds (approximately) of
each track on the CD can then be played in
sequence by pressing either
PLAY/PAUSE
on the front panel, or
PLAY on the remote
control.
Press
INTRO again to cancel introduction
search mode. If
INTRO mode is cancelled
while the X-Ray V
3
is still playing, the
remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to
store up to 25 track numbers and then play
them back in the held order. Each track is
stored as a “step” in the program.
With the CD loaded and the player stopped,
first press
PROGRAM on the remote con-
trol. The following is then displayed :
(There are 7 disc tracks in this example)
On the remote control, press the numeric
button of the track number corresponding to
the first track you wish to store (number 3
for example).
(continued . . .)
That track number will now appear in the
display :
Press
PROGRAM again on the remote con-
trol - the next program step is selected,
(prog 2) and the track number reverts to
zero ready for a new entry :
Continue entering track numbers in the same
way up to a maximum of 25. If more than
25 tracks are attempted accidently, the mem-
ory will not accept any extra ones, and the
display reverts to “prog 1”.
Remember that when entering a single-digit
track number, there is a delay of about two
seconds before the display accepts the entry
- this is to allow time for a second button to
be pressed when a double-digit number is
required.
If an incorrect entry is made, say track 9
when there are only 7 tracks available on the
disc, “INVALID TRACK” is briefly
shown, and the entry automatically can-
celled.
If at any time you wish to add a track to the
list, press the
CLEAR button to obtain the
next step number. Alternatively, to delete a
previous entry, press
CLEAR a second time
to remove the last entry. Repeated pressing
of
CLEAR will then erase each step in
reverse order.
When the last track number has been
entered, press the
PLAY button to start the
program sequence.
(continued . . .)
X-RAY V
3
Instructions for Use Page
13 of 16
Issue 2: March 2004
