5. Install the Filter Cartridge
Open the Filter Housing lid. Put the new filter cartridge into the cartridge chamber.
Replace Filter Housing Cap and seal by screwing Cap Fitting on.
NOTE:
Ensure orange ‘o’-ring
is placed correctly inside housing.
PART 5:
USAGE
Press the ‘Up’ and ‘Down’ arrows to set desired temperature, and press heat to start the heater.
Place lid on the spa while heating. It can take 24-48 hours for your spa to reach its set tempera-
ture. See Part 3 for complete list of Control Functions. Press the Jet Massage Button to activate
massage system. We suggest a temperature range between (37-39
℃
) 98.6°
F-
102°
F
during
the winter. The massage system will stop automatically after 30 minutes of operation to reduce
energy consumption.
6. Pre-Fill Check
Ensure the drain outlet is extended for future draining/access. Check the stopper on the bottom
of the spa and the Drain Cap, ensure both are closed tight. Fill the spa with water using a
garden hose until reaching the water level printed on both interior sides of the spa wall. These
lines are also used as an indication of the levelness of the spa.
NOTE:
PCU must be connected to the spa prior to filling.
NOTE:
Do not use hot water to fill Spa.
7. Purge Air From Portable Control Unit
Unscrew the Air Valve counter-clockwise and release the air until a small amount of water is
coming out, then screw the Air Valve clockwise tightly. Use a towel to dry off the PCU.
IMPORTANT:
Make sure PCU is turned off, and all connector caps are removed before
performing this step.
8. Thermal Blanket
Place Thermal Blanket on water
surface with the bubbles facing down
for more efficient heating and
improved heat retention.
(10)
Lock the Cover
Buckle
Push the square
pad upwards to
lock and
downwards to
unlock.