5) Insert the body of the liner into the centre
of the Spa, ensure the holes of the
Portable Control Unit foam fit into the
holes of the liner and the Drain Hose goes
through the hole in the bottom of the Liner.
6) Pull the Spa Top Liner down and align
with Spa Base Liner. Zip the two liners
together. TIP: Ensure top and bottom
zippers are aligned before pulling the Top
Liner down.
7) Insert the three pipes into the three holes.
These will attach to the Portable Control
Unit. The Drain Hose will come through
the bottom of the liner as well (see figure c).
Smooth out wrinkles in the liner to the
best of your ability and pat out any pockets
of air.
4) Ensure you put the cut out of the drain
(fig.b) inside to the left of the three
holes.
(fig.b)
(fig. c)
(9)
4. Connect the Portable Control Unit to the Spa
Position the PCU next to the spa, remove the Inflation Hose and align the Connection Hoses to
the spa. Use slight force to evenly push the end of the connector hose into the PCU’s
connector port. Screw to tighten and seal the connector. Attach the Aromatherapy canister
to the blower port of the PCU. Attach the remaining connector to the aromatherapy port, and
attach the other end to the corresponding connection on the spa.
NOTE:
Ensure
connectors have
‘o’-ring gaskets in
proper postion
X
NOTE:
connectors must be held straight when attaching.
Attaching at an angle can result in damage to the connector.
Aromatherapy feature
To use aromatherapy, simply unscrew cap on
Aromatherapy Port and insert canister of
scented Aromatherapy Beads. Replace Cap
on Aromatherapy Port. The aromatherapy
scents will activate once the ‘JETS’ button
has been pressed.
