opERatInG InstRuctIons
The firebox master power “on/off” switch must be switched “on” before any of the control functions, (on the firebox and/
or remote control) will operate. NOTE: The master switch does not have to be turned off when the firebox is not being
used for brief time periods. If however, you are not planning to use your firebox for extended time periods or going away
on vacation, we recommend the master power “on/off” be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control.
This feature allows you to operate the unit in 2 different ways;
• As a full featured fireplace insert with both flame effect and heater operating simultaneously.
• As a visual effect with flame effect only. (i.e. no heating cycle)
NOTE: This firebox insert is not designed to operate in “heat” only mode without a flame effect.
All of the firebox control functions can be accessed in 2 ways:
4
1. usInG tHE REmotE contRoL:
1. on/oFF: (The master power switch must be “on”)
Press the “on/off” button on the remote control, the
flame effect (only) will turn on. To turn the firebox “off”
press the “on/off” button again.
(NOTE: The “on/off” button on the remote control
does “not” control the master power “on/off” switch)
2. FLamE EFFEct: Press the flame “+” or flame “–“
button to achieve the desired effect. (no heat)
3. HEatInG: Press the heat button “once” for “low”
and/or “twice” for “high” to achieve the desired level.
(NOTE: the flame effect is always active when the
heating cycle is operational) Press the button a “third”
time turns the heating cycle off.
4. HEatER tImER: Allows you to leave your heater on while
you sleep with a delayed automatic timer for shut off.
You can set your heater to be on for ½ hour increments
starting at ½ hour up to a maximum of 7-1/2 hours –
press the timer button once for each ½ hour increment.
The red indicator light above the time selected will
illuminate to confirm the selection made. After you reach
7-1/2 hours, the next press of the button will shut off the
timer feature.
4
2
1
3
2. usInG tHE manuaL contRoLs LocatEd
on tHE FIREBox BEHInd tHE LoWER
FRont accEss panEL.
1. on/oFF: (The master power switch must be “on”) Press
the “on/off” button on the firebox, the flame effect (only)
will turn on. To turn the firebox “off” press the “on/off”
button again. (NOTE: The “on/off” button on the firebox
does “not” control the master power “on/off” switch)
2. FLamE EFFEct: Press the flame “+” or flame “–“
button to achieve the desired effect. (no heat)
3. HEatInG: (See details above under Remote Control)
4. HEatER tImER: (See details above under Remote Control)
1
4
3
2
