Operating instruction: H002 / 0938 / 0940
Edition: 01/2016
Subject to alterations.
20
5.5
Connecting the heating press to the mains and heating the splice
1. Connect the heating press to the mains.
Attention
Risk of fire or damage because of overload to the electricity supply. The electricity supply
for the heating plate must be separated from the mains according to the indications men-
tioned on the type plate! If necessary, make sure the heating press has a separate elec-
tricity supply.
2. Observe the heating temperature using the thermometer included and put it in the measure-
ment drill holes provided.
3. As soon as the heating temperature required has been reached, disconnect the heating press
from the mains by pulling out the plug on the heating plates. The data sheet for the belt pro-
vides information on the heating temperature and hold-down time.
Make sure the heating plates are not heated above 200°C as this will destroy the in-built melt fuse
or the heating resistance. You can automatically regulate the temperature using a control unit.
Warning
Risk of injury from burns. The heating plates can get very hot during heating (up to
200°C) Touching them without any protection will mean burns.
5.6
Cooling the splice
1. Only let in cooling water after the heating procedure has been completed. Only use clean wa-
ter.
2. Cool the heating press till the heating plates has reached a temperature of approx. 40°C.
5.7
Removing the belt from the heating press
1. Please empty the pressure hose.
Note:
Empty the pressure hose only after the heating press has cooled down!
2. Please open the heating press and take off the belt.
3. If necessary, clean the edges and the surface of the belt from excess material.
The belt is prepared.
4. After use, clean the heating press.