14
14
3. Slide the resistor unit (6) in the
resistor unit cradle (7) and insert the
pin of the resistor unit into the hole
in the resistor unit cradle (see figure
3).
4. Then, insert the resistor unit and the
cradle inside the smoker (2), and insert
the pin of the resistor unit into the hole
in the body of the smoker and lock it
with a nut (B) from the outside (see
figure 4).
Insert the wood chip tray (8) on the
resistor unit cradle (7).
Place the smoking grate (3) onto the
drip pan (4) and slide them inside the
smoker (2) (see figure 4).
5. Attach the lid of the smoker (5) to the
body of the smoker (2)(see figure 5).
A.
First, place the notch at the bottom
edge of the lid onto the body of the resistor
unit.
B.
Then, place the hole at the top
edge of the lid onto the hook on the body
of the smoker.
2. Attach the handle (11) and insulating board (10)
to the lid (5) using two 4.5x9.5mm bolts (A) and two
4.5mm nuts (B) (see figure 2).
2.
3.
A
B
5.
4.
