16
The cursor measurement reading function is only available when the waveform is held (Use HOLD or single time
scan). After the waveform is held, press F4 button to enter into sub-menu of cursor measurement reading function:
Back
Voltage difference
Time difference
EXIT
V
t
F1
F2
F3
The operation of the cursor measurement readout function is as follows:
1. Press F1 button (EXIT) to exit the cursor measurement reading function.
2. Press F2 button (
V) to activate the voltage difference measurement and enter into the sub-option menu of
V
measurement. This allows the measurement of voltage difference between the upper and lower cursors i.e. the crest
of measured waveform----peak value.
The sub-option of voltage difference (
V) measurement is as follows:
Back
Adjustment of cursor position
Selection of cursor
EXIT
▼
▲
UPPER
F1
F2
F3
F4
a. Press F1 button (EXIT) to exist the sub-option menu of voltage difference measurement and back to the
sub-option menu of cursor control.
b. Press the F2 key (▼) and the F3 key (▲) to adjust the position of the cursor.
c. Press F4 button to switch for upper or lower cursor (UPPER/LOWER).
3. Press F3 button (
t) to activate the time difference measurement and enter into the sub-option menu of
t
measurement. This allows the measurement of time difference between the left and right cursors and the
