24
DEUTSCH
HOCHPEGELEINGÄNGE CH1-4:
Schließen Sie hier die verstärkten Lautsprecherausgän-
ge an, die von vom Autoradio kommen. Die Eingangs-
empfindlichkeit ist mit dem Regler CH1/2/3/4 von 3,5
bis 11 V RMS einstellbar. In CH1 ist autom. Einschalt-
funktion (Auto-Turn-On) integriert und muss unbedingt
angeschlossen werden.
LAUTSPRECHERAUSGÄNGE CH1-4:
Schließen Sie hier Lautsprecher (2 - 4 Ohm) gemäß an
Ihrem Soundsystem an.
Wenn Sie die Lautsprecherausgänge (BTL-Modus)
brücken und die angeschlossenen Lautsprecher/ Sub-
woofer mit 4 Ohm betreiben möchten, brücken Sie die
Kanäle wie folgt:
Kanalpaar 1: SPEAKER OUT1+ (+) & SPEAKER OUT2- (-) mit 4 Ohm
Kanalpaar 2: SPEAKER OUT3+ (+) & SPEAKER OUT4- (-) mit 4 Ohm
1:
11:
2:
12:
3:
13:
4:
14:
5:
15:
6:
16:
7:
17:
8:
18:
9:
19:
10:
20:
HOCHPEGELEINGANG 3 -
HOCHPEGELEINGANG 3+
HOCHPEGELEINGANG 1-
HOCHPEGELEINGANG 1+
HOCHPEGELEINGANG 2-
HOCHPEGELEINGANG 2+
HOCHPEGELEINGANG 4-
HOCHPEGELEINGANG 4+
LAUTSPRECHERAUSGANG 4-
LAUTSPRECHERAUSGANG 4+
LAUTSPRECHERAUSGANG 3-
LAUTSPRECHERAUSGANG 3+
LAUTSPRECHERAUSGANG 2-
LAUTSPRECHERAUSGANG 2+
LAUTSPRECHERAUSGANG 1-
LAUTSPRECHERAUSGANG 1+
BATTERIE-
B
BATTERIE-
B
3
4
5
SYSTEM-STECKER
Anschluss für den beiliegenden ISO-Kabelbaum. Stellen Sie sicher, dass Sie nur den mitgelieferten
Original-Kabelbaum verwenden, um den Verstärker mit Ihrem zu verbinden.
3
Die Ausgänge nicht parallel schalten, sonst kann der Verstärker beschädigt werden.
ACHTUNG
NIEDERPEGELEINGÄNGE CH1-4 (optional, nur M6
v2
):
Wenn Sie den Verstärker mit Niederpegelsignalen
(z.B. mit den Vorverstärkerausgängen des Autoradios)
ansteuern möchten, beachten Sie bitte die Hinweise auf
Seite 32.