203
AP-75370 - Revision 1.1
User’s Guide Kona / Kona apparel cutting plotter
Troubleshooting
6251
Thickness
problem
frame centre
Thickness of centre points (P9 & P10) differs too much from each other AND
differs also from bottom points P1 and P4.
You can try to cut the job if you want
to. Perfect quality is not guaranteed.
What to check in case of bad quality:
Printer settings
RIP settings
Design
Refer to
Warning
6252
Thickness
problem
frame centre
Invalid thickness of P9 (right centre point). Thickness varies too much from P10!
This will influence the accuracy of the cutting.
6253
Thickness
problem
frame centre
Invalid thickness of P10 (left centre point). Thickness varies too much from P9!
This will influence the accuracy of the cutting.
6254
Thickness
problem
frame centre
Thickness of centre points (P11 & P12) differs too much from each other AND
differs also from bottom points P1 and P4.
6255
Thickness
problem
frame centre
Invalid thickness of P11 (right centre point). Thickness varies too much from P12!
This will influence the accuracy of the cutting.
6256
Thickness
problem
frame centre
Invalid thickness of P12 (left centre point). Thickness varies too much from P11!
This will influence the accuracy of the cutting.
Error Message
Description
Solution
Category
Summary of Contents for Kona 1400
