User’s Guide Kona / Kona apparel cutting plotter
Operation panel
AP-75370 - Revision 1.1
87
4
Step 3:
Weed out the following squares.
Step 4:
Check if the top layer is cut completely and that you can see a slight scratch on the
backing.
Offset
One of the most important factors to obtain good quality, is the offset. As you can see in the
figure below, the knife offset (
1
) is the distance between the knife centre and the knife tip.
Accurate measurement of the used
offset
is very difficult and requires specialized equipment.
You should therefore adjust the offset (1) by checking real cutting results on the media you
will use. Mutoh helps you doing this by way of a semi-automatic offset adjustment routine,
integrated into your cutter.
When a pen is loaded, no offset is necessary as the pen point is in the centre of the pen head.
When loading a drag knife, the pen tip is not in the centre of the pen head and an offset is
necessary.
Please follow the procedure below to perform this test:
Note
If the active tool is a pen tool, then the Offset button is disabled.
1
Summary of Contents for Kona 1400
