Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions
11
AP-75125, Rev 1.3 ; 20/10/04
2. INSTALLATION PROCEDURES
2.1. PREPARING THE CUTTING ENVIRONMENT
The location where you set up your equipment is very important. Please see to it that it meets following
conditions :
Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
Ambient Conditions :
Operating environment
- Temperature : 5 °C to 30 °C
- Humidity : 35 % - 75 % non-condensing.
Recommended environment
- Temperature : Room temperature 16 °C to 25 °C
- Humidity : 50 % to 65 %, non-condensing.
Variation rate
- Temperature : 2 °C per hour.
- Humidity : 5 % per hour.
Storage environment
- Temperature : 0 °C to 50 °C
¾
Please protect your cutter from moisture, dust, draughts and direct sunlight. It is best to keep your
machine away from open windows and air-conditioners.
¾
See to it that there is an adequate space around the cutter so that ventilation is not obstructed.
¾
Avoid unnecessary vibrations and set up your cutter on a level surface.
¾
When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at the rear, as shown in
the illustration below.
Summary of Contents for Ultima 1400
Page 2: ...2 AP 75125 Rev 1 3 20 10 04 ...
Page 4: ...Mutoh Ultima Multi Purpose Cutting Plotter Operation Instructions 4 AP 75125 Rev 1 3 20 10 04 ...
Page 6: ...Mutoh Ultima Multi Purpose Cutting Plotter Operation Instructions 6 AP 75125 Rev 1 3 20 10 04 ...
Page 8: ...Mutoh Ultima Multi Purpose Cutting Plotter Operation Instructions 8 AP 75125 Rev 1 3 20 10 04 ...
