ValueCut USER MANUAL
Operation
53
VC2E-A-00
4.4 How to Cut 3 mm Letters
To obtain good quality output, narrow media is recommended. However, if wide media is used, you
should:
1.
Position two pinch rollers as close as possible to both edges of the cutting area.
2.
Make sure the loaded media is held flat with equal tension across the platen.
3.
Suggested operation settings:
Tool Force: 55 gf. (or depending on the material)
Cutting speed: 45 - 50 cm / sec
Tool up speed: 45 - 60 cm / sec
Smooth cut: Disable
Quality: Small Letter
4.5 How to Make A Long Plot
When you are making a long plot with a roll of heavy and wide vinyl, paper you need to use the “AUTO
UNROLL MEDIA“ function. The following parameter settings are to help users get the best cutting quality.
The actual output quality may vary when using different kind of materials.
1.
If the length of graphic is between 3 m and 5 m, the cutting speed is better
slower than 72 cm / sec and the cutting quality is set as Normal.
2.
If the length is longer than 5 m or if the material type is difficult to cut, it is
better to further slow down the cutting speed.
3.
After loading the roll media all pinch rollers are raised at this stage, flatten
the media on the platen and hold the front edge of the roll media firmly.
(Figure 4-15)
Figure 4-15
Summary of Contents for ValueCut II Series
Page 60: ...Automatic Aligning System ValueCut USER MANUAL 60 VC2E A 00 Figure 5 1 Figure 5 2...
Page 111: ......
Page 112: ......
