6.2.1 Starting Up
350
6.2 Operations in Maintenance Mode 2
VJ628XE-M-00
(1-b)How to start the Maintenance Mode 2
(1-c)Maintenance Panel Display and Operation
㨀㧵㧼
6.2 Operations in Maintenance Mode 2
1
Click [Boot Mode] and choose either [Self-
Diagnosis Mode] or [Maintenance Mode 2].
Then, choose language.
CAUTION
• The Maintenance Panel is not
available until the PC is properly
connected to the printer after the
mode selection.
• The selected language is reflected in
the Maintenance Panel until the
printer is powered off.
The initial language setting is
reflected in the printer.
2
When the printer is successfully switched to
the mode you selected, the complete
message will appear as shown at right.Click
[OK] to go back to the Maintenance Panel.
CAUTION
• The LCD display on the
Maintenance Panel is updated.
• The Maintenance Panel becomes
available after the proper connection
Exit the Maintenance Panel.
The button operationcan be
changed by clicking.
Long (press)
:
Press [Shift]key and keyboard
key
10cnt
:
Press [Ctrl] key and keyboard
key
Display the Help window.
The keyboard operation is also available as below.
ESC key
→ key
↓key
Enter key
Backspace/Delete key
HOME/Space key
↑key
← key
Press [Shift] key and keyboard key:[
Long (press)
]
Press [Ctrl] key and keyboard key :[
10cnt
]
Choose Seltf-Diagnosis Mode/
Maintenance Mode 2 and
choose language.
Display the communication
status with the printer.
Recv: Printer information
receiving status
Send: Button input sending
status
Recv/Send
Green Light:
Communication Success
Red Light:
Communication Failed
Clicking button to operate the
Maintenance Panel.
Right-clicking stops the operation.
The
[STOP]
button is implemented
only for the Maintenance Panel to
stop the operation of
“Long (press)”
ant
“10cnt”
.
Short
(press)
Long
(press)
10cnt