© MuxLab Inc.
Audio 8x8 Matrix Switch Installation Guide
Page 44
5. POST Commands
POST commands will always return 1 of 5 HTTP headers:
HTTP 201Created
Command was successful
HTTP 400 Bad Request
Received argument was malformed
HTTP 403 Forbidden
User does not have sufficient privileges
HTTP 404 Not Found
URL is incorrect
HTTP 501 Not Implemented
URL does not support receiving POST data
URL
Argument
/var/conn.json
Array of connections.
(Same as GET above)
Example: [0,1,2,3]
/var/connio.json
Single connection
JSON data = [input#, output #]
Example: [2.3] (to connect input #2 to output #3)
/var/pre1.json
/var/pre2.json
/var/pre3.json
/var/pre4.json
/var/pre5.json
/var/pre6.json
/var/pre7.json
/var/pre8.json
Array of connections for a preset
(Same as GET above)
Example: [0,1,2,3]
/var/boxname.json
Array of a single string.
Contains the name of the box, limited to 20 characters
Example: [“Classroom B Matrix”]
/var/sources.json
Array of 4 strings.
Contains the names of all 4 input ports.
Example: [“Cable Box”, “Satellite Receiver”, “Demo Reel”, …]
/var/displays.json
Array of 4 strings.
Contains the names of all 4 output ports.
Example: [“Conference Room”, “Cafeteria”, …]
/var/presetnames.json
Array of 8 strings.
Contains the names of all 8 presets to be set
Example: [“Preset 1”, “Preset 2”, “week end”, …]
/var/auth.json
Array of 2 strings.
Contains a single digit string representing the user level requested, and a second string representing the password.
Example: [“2”, “myAdminPassword”]
/var/serial.json
Array of 4 integers.
Set the following serial port settings: baud rate, data bits(7 or 8), parity (0=>Even; 1=>Odd; 4=>None) ,stop bits
(0=>1 stop bit; 2=>2 stop bits)
Example: [9600,8,4,0]
/var/ip.json
Array of 4 integers.
Set the IP address
Example: [10,0,101,96]
WARNING! This request will actually take effect after the DHCP request will be sent
/var/netmask.json
Array of 4 integers.
Set the mask address
Example: [255,255,0,0]
WARNING! This request will actually take effect after the DHCP request will be sent
/var/router.json
Array of 4 integers.
Set the gateway address
Example: [10,0,1,1]
WARNING! This request will actually take effect after the DHCP request will be sent
/var/dhcp.json
Array of a single integer.
Set the DHCP state ON ([1]) or OFF ([0])
Example: [1]
var/pass_admin.json
Array of 2 strings.
Set the web administrator password
Example: [“old
admin
password”, “new admin password”]
var/pass_user.json
Array of 2 strings.
Set the web user password
Example: [“old
admin
password”, “new
user
password”]
var/reset
Reset the unit to factory settings
