© MuxLab Inc. 2014
7
Using the product with DIP Switches
Before installing the product to their final location it’s recommended to configure the units
1.
Configure a different address using the DIP switches for each encoder that will be present on
the network. Note: It’s important that each encoder have a unique address.
2.
Configure each decoder using the DIP switches to select the right encoder.
3.
Follow the procedure explained in the installation guide to install the units.
Using the product with the Muxlab Software
1.
Follow the procedure explained in the installation guide to install all the units.
2.
Install the software on a computer that is connected on the same network as the 500752 units.
Note: the computer network interface should be configured to use DHCP if a DHCP Server is
present, else configure the computer network interface to use the same subnet as the 500752,
like 192.168.168.1.
3.
Execute the software. Click the ‘Yes’ button to perform a full network scan.
4.
The first time the software is executed you will get a warning that all the products have the
DIP Switches enable. Select ‘Yes’ and click ‘proceed’.
5.
Go to the Matrix Connection tab to do the desired connection between the 500752 Encoder
and Decoder. Note: More information is available in the Software Manual.