Packing list
Radio
(1)
/power cord
(1)
/FM antenna
(1)
/instruction book
(1)
/
warranty card
(1)
Specifications
Frequency range: FM
87
MHz-
108
MHz AM
520
KHz-
1700
KHz
Acceptance sensitivity: FM:
3
uv AM:<
1
mv
Signal to noise ratio: FM>
50
db AM>
40
db
FM separating degree
35
db Bluetooth:
55
db
Selective: FM>
40
db AM>
30
db
The distortion: FM
1
% AM
1.5
% Bluetooth
0.5
%
Maximum output:
20
W
Power consumption:
30
W
Loudspeaker:
4
-inch bass+
1
-inch silk membrane treble
Physical size:
160
mm*
290
mm*
164
mm
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part
15
of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference
that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
I
SED
Warning
-English Warning Statement:
"This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device."
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
-French Warning Statement:
"Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement."
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels of RF energy that are deemed to
comply without testing of specifc absorption ratio (SAR).Cet équipement est
conforme aux limites d'exposition aux rayonnements énoncées pour un
environnement non contr?lé et respecte les règles d'exposition aux fréquences
radioélectriques (RF) CNR-102 de l'IC. Cet équipement émet une énergie RF très
faible qui est considérée conforme sans évaluation du débit d'absorption spécifque
(DAS).
The device complies with RF specifications
