20
Appendix
This appendix contains links to reference
documents explaining the technologies that
your terminal uses:
Document
Link
Technical features
NeptuLink_Datasheet_EN.pdf
Configuring your computer for
DHCP
To access your terminal, you will need to use
the DHCP (Dynamic Host Configuration Proto-
col). Your terminal will contact a DHCP server,
which automatically assigns an IP address to
the computer connected to the Ethernet port.
To activate DHCP, follow the steps below:
➊
Click Start
, then Control Panel and
Network and Sharing Center.
➋
To display the network connections, click
the Change card settings link on the left-
hand side of the Network and Sharing
Center panel.
➌
Right-click the connection you wish to
change, then click Properties
. Enter
an administrator password or confirm the
change if prompted to do so.
➍
Click Internet Protocol version 4 (TCP/
IPv4) then Properties.
➎
Click Obtain an IP address automatically.
➏
Click Obtain DNS Server addresses
automatically.
➐
Click OK to close the dialog box. Your
computer is now configured for DHCP.
