13
M1.2.CAT420.NLFREN 24092018
EN
TOOLS
2 Assembly instructions
1.
Remove all parts from inside cabinet including floor gate from bottom of crate, underneath cardboard.
2.
Place cabinet on its top.
3.
Attach legs using four 1/4’’ x 1/2’’ bolts.
a) Front left leg has name plate.
b) Rear legs will also take 2 self tapping screws each.
4.
Stand cabinet upright on legs.
5.
Attach bracket with pressure gauge (8) to left front leg with two 1/4’’ x 3/4’’ bolts, lock washers and nuts.
6.
Place foot pedal between front legs.
7.
Attach metering valve using three self-tapping screws to back bottom on cabinet. Snap closed with door catch.
8.
Attach left and right doors with four nuts.
9.
Loosen bolts on door catches and move out to full extend and tighten bolts. Moving them in slightly will tighten door
seal.
10.
Place glass on top of cabinet.
11.
Place light fixture on glass with light switch on right side. Fasten to cabinet with four 1/4’’ x 3/4’’ bolts and flat
washers.
12.
Dust collector:
a) Attach body of dust collector to rear panel (right side) aligning pipe with hole. Use 1/4’’ x 3/4’’ bolts and flat
washers.
b) Place top of dust collector (with motor and filter) into top of unit. Do up the 2 catches.
c) Remove inlet box that covers the dust collector pipe inside the cabinet and place a bead of caulking around pipe
to seal it. Replace inlet box.
13.
Tighten all bolts, nuts and screws.
14.
Place floor grate with cut out corner to front right of cabinet. Bring hoses through opening.
15.
Plug dust collector into female plug coming from light. Then plug male cord from light into the power outlet. Turn on
switch of vacuum, the switch on cabinet will turn on light and vacuum or dust collector.
16.
Put media into cabinet through floor grate (about 1/4 bag).
copyrighted
document
- all
rights
reserved
by
FBC
