5
Subject to modifications
• 19, rue de Rennes • BP 83221 • F - 35690 ACIGNÉ
2.
OPERATING REQUIREMENTS
2.1
Implement hitching.
The front linkages are designed to receive implements which comply with the hitch dimensions specified in ISO 8759-1
standards for category II.
The distance of the implement’s hitch points must
be 436 (dimension A, cat. 1N standard) with a linkage pin
of 22 mm diameter (Ø D).
The vertical height of the implement must be 360
(dimension H).
2.2
Front overhang and use on the ground.
The implement must be hitched as close as possible to the attachment points on the front linkage. In fact, the longitudinal
overhang generates considerable stresses on the front linkage (due to leverage). The more compact the implement fixing,
the less strain there will be on the equipment. Using a compact implement also improves lifting performance.
This category of linkage is not designed for working the ground. You are strongly recommended not to fit soil engaging
implements, so as to safeguard the structure of the machine.
Caution!
Requirements for implement hitching and for working on the ground must be strictly complied with. Any deviation from
the requirements risks causing serious damage for which MX cannot be held liable.
Hitching an implement with a dimension H less than that specified above will overload the upper link bar, causing
damage to it.
Hitching an implement with dimension H in excess of that specified above can cause damage to the front of
the tractor (bonnet, grille, etc.) on lifting.
