PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
IMPORTANT INSTALLATION INFORMATION
2.
Before commencing installation or maintenance, ensure
electricity is switched off at the mains. Installation or
maintenance should be carried out by a qualified electrician.
3.
The luminaire must not, under any circumstances, be
installed directly to flammable materials, and luminaires
must not be covered with any flammable materials.
4.
Mounting height range of 0 to 40 meters, this model is
suitable for outdoor lighting.
5.
Ensure there is adequate free air circulation of at least
50cm around the luminaire. All luminaires run hot. It is
the installer's responsibility to consider fire risk and take
appropriate precautions.
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER
FOR FUTURE REFERENCE
1
2
U-bracket
U-bracket
locking screws
Mains power supply
Facade or other
mounting surface
U-bracket
STEP 1:
Unscrew screws from the yoke mounting bracket using an Allen .
See Figure 1.
STEP 2:
Get the mains power supply cord through wiring hole on U bracket, then
fix U bracket to facade or other location using swelling bolts or other screws.
See Figure 2.
3
Locking screw
Locking washer
Securing plate
4
Junction Box
5
U-bracket
locking screws
STEP 3:
Fit lightbody into the hooks of U-bracket, and make sure the
locking washers must be located between U bracket the lightbody.
See Figure 3.
STEP 4:
Tighten the screws slightly, rotate the lightbody and make it easier for wiring,
then connect mains power supply to the power cord of lightbody,
See Figure 4.
For more details about wiring, please refer to the wiring instruction
to compete wiring,
see Figure 7.
STEP 5:
Loosen the screws on both sides of U bracket, rotate the lightbody
to a specific aiming direction for illumination, finally lock the screws
at 45 N.m torque to complete installation.
Installation Instruction & Installation Steps
6
Mounting C
:
OPTIONAL MOUNTING with Suspension rope: Hang the thimble secured
by an eyesplice on the hook.
Stainless steel
hanging wire
Hook
LED Flood/Area Light
INSTALLATION INSTRUCTION
MLLG-AX-LED-HM-600-5000-U
1.
Normal operating environment and temperature: -40
℃－+
50
℃.
Fixtures is suitable for Airport, Car Dealerships, Achitural,
Factory, Warehouse, High Mast lighting and stadium lighting.
H
W
L
Drawings herein for MLLG-AX-LED-HM-600-5000-U are used as examples for the below listed models.
