Color
Function
What to Look For
Orange
Cellular Network
Blinking = Searching
Solid = Cellular signal is OK
Green
GPS Network
Blinking = Searching
Solid = GPS Signal is OK
Verify LED Status
Test the installation by turning the car on and off, opening and closing the driver's door, and turning
lights and dome lights on and off. Constant power should not be interrupted by these actions, and the
device should continue to operate as you can tell by looking at the lights.
The GPS device is intended to be inside the cabin of a vehicle, and is not waterproof. It is not designed
to be mounted externally or under the hood of a vehicle. The GPS device contains internal Cellular and
GPS antennas, so the location and orientation of the device is important for reliable tracking. The
location should be somewhere such that no metal is between the device and the sky. A typical location
is under a plastic dashboard in the area under the windshield.
You can mount the device using zip ties, strong double sided tape, or similar items.
Mount it with the
label facing down
, because the antenna is on this side. Conceal and secure the wires of the harness,
and trim or bundle up unused wires. Make sure that wires can't fall into visible areas of the vehicle
and be tugged. Make sure that they are not in locations where they may be damaged by the operation
of pedals, glove boxes, fans, heaters, etc.
Testing The Installation
Starter Interrupt (SID) Installation
Optional
Tracker Mounting Guidelines
1.
With a Voltmeter, find the wire from the key that activates the starter.
2.
This link may help you identify the correct wire for different vehicles
http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspx
3.
Cut the wire, and connect the
Blue
wire from the SID to the end which goes
toward the key. It should show about 12V when the key is on Start, but 0V
otherwise.
4.
Connect the
Red
wire from the SID to the other cut end of the Ignition wire.
5.
Connect the Green wire from the SID to the Green wire from the Tracker.
There are a number of videos and guides on the internet, but note that relays
come with many different colors of wires. You should go by the position in the
relay socket, not just the color of the wire.
To Starter
To Key
Switch
CUT
To Tracker
Green Wire
Starter
Wire
Relay
