Error messages
EEEE: Overload
: Low battery
Weighing procedures
1.
Press [ON/OFF] to turn on the scale.
When the power is turned on the display will show all segments (88888) for a few
seconds and then "0" will appear on the display.
2.
Select the weighing unit with [MODE].
Press
[MODE]
to select the weighing unit, eg. "g"
?
"oz" or "dwt".
3.
Start weighing
Place the objects to be weighted in the weighing container or directly onto the scale’s
tray.
When the reading becomes stable, the stable weighing indicator is displayed.
Counting procedures
1.Press [ON/OFF] to turn on the scale.
Wait for "0" to appear on the display.
2.Start the Count Procedure
If necessary, press [ZERO] key to set the display to “0”.
3.
Place a given number of samples of an item in the container (the Sample Size should
be either 10
?
20
?
50 or 100 pieces). The weight of these samples will show on the
display.
4.
Press [Mode] and select the counting Mode.(e.g. count). The indicator on the right side
of the display should point to COUNT
5
. Select the sample size (the same as you chose above) by pressing the [NW/GW] key
(the sample size is the same as in step two =10
?
20
?
50or100),
6.
Press the [Mode] key, The scale will show CAL and then the sample sized you selected
will show on the display.
7.
Place the items that you want counted in the container and the total number of items
will show on the display.
*Basically, the scale is now set for Counting your items. It knows that the number of
samples that you now have in the tray is (for example) 20 marbles. So if you add a bunch
of marbles it will calculate the total number of marbles (based on the weight of the
starting sample) and show you that number on the display.
NOTE: the weight of unit sample > 1e.
