Start vehicle and crank the engine in 2-3 second bursts. Do not crank the engine for more than 5 seconds.
Allow the booster battery to cool down after each boost.
If vehicle fails to start, turn OFF the ignition, disconnect the jumpstart system’s leads, and contact a quali-
fied technician to investigate why the engine did not start.
Finally, remove cables in reverse order of connection by disconnecting the engine block connection of the
formerly stalled vehicle first, followed by the second post attached to of the booster batter, followed by the
first post attached to of the booster battery, and finally the post on the formerly discharged battery.
Maintenance
WARNING
Procedure not specifically explained in the manual must be performed only by a qualified
technician.
Make sure all four clamps are not connected to a wire or terminal before performing maintenance.
-
+
-
+
+
RED
BLACK
-
+
-
-
