9
Figure 2: Example of a suitable location for installation.
Be extremely careful with the cooling areas of the oven. If it sucks in
vapours or hot air it can drastically reduce the life span of the components.
For the installation of Mychef stacked ovens, follow the instructions
supplied with the corresponding stacking kit.
5.
INSTALLATION
5.1
Electrical connection
Check that the voltage reaching the point where the oven is to be switched on
corresponds to the operating voltage of the equipment.
Before carrying out any electrical work, make sure that no electrical current is supplied
at the point of connection of the equipment.
The device must be connected to the mains via an all-pole switch with a contact
opening distance of more than 3mm. Also install a class A differential device and an
overcurrent protection.
Always ensure effective grounding.
Connect the equipment to an equipotential bonding system
using the contact
specially provided for this purpose (see equipotential bonding sign on the bottom left
of the equipment). If two pieces of equipment are stacked, both must be connected to
the equipotentiality system.
1000m
m
500m
m
50mm
50mm
50mm
Summary of Contents for Bake
Page 1: ......
