13
The icon that identifies it is the "AIR" icon and selecting each type of recovery is done using the
icons below it: "FAST","SOFT" and "STOP".
-
Repeat multiple vacuum cycles:
It is possible to program series of repetitions of the same vacuum cycle, i. e. it allows
the vacuum to be carried out and the atmospheric pressure in the packaging machine
to be restored cyclically. In each repetition, the packer reaches the vacuum value set in
the "Vacuum percentage" parameter. If this is 100% and an extra vacuum time is set,
this time is also completed within each repetition. The atmospheric pressure inside the
chamber is then recovered. This recovery is not fully completed as a small percentage
of vacuum is kept in the chamber to avoid opening the lid, allowing another repetition
to start automatically.
This process will perform as many repetitions as defined in this value, with a maximum
of 9. The icon that identifies it is the "REPEAT" icon and the digit below it marks the
number of repetitions remaining.
The gas injection is compatible with the cycle repeat mode, although it should be
noted that the gas will be injected only at the last repetition, in the same way that it is
injected when sealing is performed.
7.3.3
Autoclean:
When the oil in the vacuum pump has become whitish due to water condensation, this can be
removed with this mode. This process helps the water in the oil to evaporate due to
temperature.
These water particles can cause rust particles to appear in internal pump components.
Every 200 vacuum cycles, the vacuum packer will alert the user to perform a self-cleaning
process. This will happen when the machine is connected or switched on. If the lid is
closed during this period the "AUTO-CLEAN OIL" process will start automatically.
If you don't want to do the AUTOCLEAN at the time of the warning, you can rotate the
encoder to navigate through the menu and perform the cycle of your choice.
An AUTOCLEAN cycle can be performed whenever desired by entering the AUTOCLEAN mode
manually in the operating mode selection menu. The maximum duration of the AUTO-CLEAN
mode is 20 minutes, although it can be stopped by pressing the encoder button.
7.4
Packaging
In order to pack a product, the bag (suitable for vacuum packaging) must be placed correctly
on top of the polyethylene plate, the entire bag width must be above the sealing area. Make
sure that there is no product on the sealing bar. Then lower the lid of the packaging machine.
It is important to remember that a packaging process cannot be started while the manual
mode parameters are being set.
NOTE: It is recommended to use the safety latch on each packaging cycle, at this point the
active mode or program is started and the indicators of the processes to be carried out
