16
03
ASSEMBLY & MOUNTING
The stand should be placed on a flat surface or on a level floor.
Assemble the stand:
Connect the two curved foot parts (2,3) with the T-piece (1) of the foot and
fix them each with a long hexagon socket screw (7).
1.
MOUNTING THE STAND
Assemble the arch:
Connect the lower part of the lower half-moon part (4) to the assembled
stand. You can fix it with a long hexagon socket screw at the back (7). Place
one short hexagon socket screw on each side to fix it tight.
Finally, attach the upper half-moon part (5) and fasten it using a short hexa-
gon socket screw (6). Cover the screws at the foot part with the caps (8).
2.
Assemble swinging hammock:
You already have a baby hammock? Use the snap hook to hang it into the
eyelet provided. Make sure that the hook is closed. An extension chain (link
chain) is not needed while using the baby hammock and can be stowed
away for later use.
IMPORTANT:
Make sure that the baby hammock is always hung in a
free-turning position. To absorb torsional forces from the spring, the swivel
should therefore always be attached with the spring.
3.
IMPORTANT:
Assembly should be carried out by an adult. If in doubt, consult qualified
personnel.
