D-Link Technical
Support – How to install the DCS-930L.
Page
2
of
16
1. Connect the included Ethernet cable to the network cable connector located on the top panel at the rear
of the DCS-930L and attach the other end to your network, the network will usually be a LAN port on your
Router.
Ensure to attach the external power supply to the DCS-930L as well.
2. Insert the Installation CD-ROM into your computer's optical drive and start the autorun program. You can
also browse the contents of your computer's optical drive and double click on the "autorun.exe" file as well.
If you have downloaded the Setup Utility from the D-Link Support Knowledge Base, and have extracted the
archive (*.zip file), you can also double click on the "autorun.exe" file as well.
NOTE: For any prompts that require permission to run, it is best to 'Allow', 'OK' and or 'Accept' the files to
run and or be installed.
3. Click the Start button to begin the setup:
